Xecuter 2.6CE Lite & Xapter Solderless installation - BLANK SCREEN

[[DarkGUNMAN]]

Ok... heres what Ive done so far

Purchased the Xecuter 2.6CE Lite & Xapter, installed the Xapter as guided from the supplier - being VERY carefull to make sure it has been fitted correctly
http://www.kanection.co.uk/page.php?xPage=xapterinstall.html

Chip Enabled, Flash Protecton Off, Bank 1 set.
Flashed the chip using x2_5032_v16plus_512k.bin by HTTP

Xbox reset, blank screen for between 5-10 seconds, standard intro sounds, but blank screen continues, no change afterwards.

What have I done wrong? Please help

 

[MKChampion]

x2_5032_v16plus_512k - 1.6/1.6b versions

x2_5032_vOld_512k - 1.0-1.5 versions

you've flashed the wrong bios

 

[[DarkGUNMAN]]

I did try flashing the other bin file, but it gave an exception saying it was the wrong bios file, then halted

 

[MKChampion]

if it says unknown flash, halting
this indicates that you've left the flash protection on
swtich off the flash protection before booting from the external swtich and try again