Xecuter 2.6CE with 1.0 xbox frag

[f8-02]

I have 2 xbox's ver 1.0 motherboard. 2 new Xecuter 2.6CE w/ Xapt3r

Xbox 1- has mod from 2yrs ago with X2 Light Plus was working fine till I put new Xapt3r w/2.6ce. Xapt3r has 3 blue leds on left side and 1 red on top right with out mod chip. Turns on/off 3 times then green/red frag.
LPC pin header check with out modchip
1 - .0 - lclk ( problem?)
2 - 0 - ground
3 - 3.3 - lframe
4 - removed
5 - 0.195 - reset (problem here?)
6 - 5.16
7 - 3.3 - lad3
8 - 3.3 - lad2
9 - 3.3 - 3.3v
10 - 3.3 - lad1
11 - 3.3 - lad0
12 - 0 -ground
13 - 3.3
14 - 3.3
15 - 3.3 - 3.3v
16- 3.3
Did wire instal and still frags and has the same volts on pin header.

Xbox 2- Never been moded, Xapt3r has 3 blue leds on left side with out mod chip. boots up fine. Now once I install the 2.6CE modchip the red lcd is on and so are the 3 blue ones. It works fine. Even swithced chips to make sure 1 isnt bad.

I have been reading and searching for 2 days and I am stuck.

 

[Dreamreaper]

How did you remove the X2 lite, more so was it a solder install AKA pinheader or wire, if so why fit a solderless adapter, did you remove the origional D0 install? use braid, solder sucker?

 

[f8-02]

The X2 Lite Plus has pogo, solderless. I just unscrewed it and put new Xapt3r in its place. After that failed and tried everthing I have read on all post and still failed I tried the wire instal since there is solder in the holes, all went real easy there but still frags.

 

[f8-02]

Any one Know why Pin 1 and Pin 5 would have these readings?

 

[Fantmx]

Did you clean the LPC contact points with a stiff eraser or a q-tip with a little bit of nail polish remover?

 

[f8-02]

I used a small driil bit the size of the holes and took of the top layer. Worked great on the other one. but the other two have the same readings.

 

[Fantmx]

A drill on a motherboard?! That doesn't sound good. Take a look with a magnifying glass to be sure you didn't damage anything.