LITEON DG-16D4S - SLIM Xecuter PCB problem, dont' get in Vendor Mode ! Satus 0x51

[2nsWexx]

Hello got a problem.

I have installed in me a Xectuer PCBs and wanted to flash with the Jungleflasher, what did not work. Then I used Dosflash and there was no problem to write the new LT+ on it. Now I wanted to write on a new firmware, but I get the drive is no longer in the vendor mode, the status always changes between status 0x51 and status 0xD1 when I turn on and off ( can't get into Status 0x71), it does not matter in what position the switch on the PCB whether that is on WP1 or WP0 .

I would appreciate if someone could help someone like you again get the Xecuter PCB vendor in the mode!

Sorry for my english
greeting
2nsWexx

 

[x360ccm]

bit more info be good.your drive.tools you are useing.

 

[2nsWexx]

I used Maximus Xtractor V.1 for electricity and a via 6421 card, but I've now ordered a Xecuter X360USB PRO, but not the mind that brings me into the case further, since the drive is indeed detected as in Windows XP. My onboard Sata ports do not recognize the drive, so I think this on the Via 6421 nothing can be wrong. that is all that is what I use:

- Windows XP
- Via 6421 card
- Maximus Xtractor V1

My XBox 360 Details don't be shown here, I don't know why !
But it's a XBox 360 Slim 250GB Version with a Liteon 9504 which is now an 0272 because the last update.

 

[2nsWexx]

Hello anyone ? Please help me.