Xecuter3CE can´t select anything in Flashbios

[obelixthefreak]

Hi Folks,

i have the Problem that i can´t select anything in the Flashbios... the controller didn´t work...

If i start with longboot (M$) the Controller works fine...

If i start with Backup same failure...

The Chip is new and first inst...


Please HELP!!!

THX

Obelix

 

[DJBOOBY]

Try to unplug controller in flashbios then replug in try all points or if you are useing a non ms xbox controller that could be the prolbem

 

[obelixthefreak]

Hi DJbooby,

it is a M$ S-Controller and i try all ports replug has no efect...

The Controller works fine i M$-Dash with loongboot...

 

[islander223]

If you have a dvd playback kit, try using it...

 

[obelixthefreak]

ok i try but i have use 2 controllers with same efect

 

[islander223]

have you tried changing banks? If you have a v1.0 - v1.5, try switching from flashbios 3.01 to flashbios 3.03 or vice versa.

 

[obelixthefreak]

The box is 1.6 and i have change the banks but is a new chip and i use 1MB 1=on 2=on 3= off 4=off unprotect to flash

 

[DJBOOBY]

not 100% but get your hands on flashx3 software and try that

 

[jafster]

i had the same problem on my new 1.6b - it wouldnt take the original s type pad ..
if you look you will notice that the wire on the new 1.6 pads are different to the older versions pads- in this i mean they have got rid of the twisting up effect you get on the older pads compared to the new ones which dont twist up- maybe thats the reason i dont no- but i put my older version pad in and i was able to move again in cromwell

 

[DJBOOBY]

try the 256k banks restart xbox every switch change

"256k Bank
Bank 1: on on on on
Bank 2: off on on on
Bank 3: on off on on
Bank 4: off off on on
Bank 5: on on off on
Bank 6: off on off on
Bank 7: on off off on
Bank 8: off off off on