Are the rest of your settings for your drive off? That image you uploaded is really nice!Burner - ihas124b with c4eva max firmware
Disc - Singapore Verbatim 43666 8x
Burning program - ImgBurn with OPC enabled
Write & Read Speed - 4x
Verify against image - Off
Backup Image - Battlefield 3
Smartburn - enabled
I was recieving the same results from my backups when using MKM001 Singapore Verbs... (the rising spikes at the end of the second layer of the disc)Ok i have seen multiples images and test, now i have burned my backup and i alwayes get that test and the end its goes up the PImax, i know the its a good burn but i dont understand why its always and the end of the second layer the problem
Smartburn = Enabled
Force Hyper Tuning = Enabled
Over Speed Writing = Desabled
Online Hyper Tuning = Enabled
Drive - Liteon iHAS524B
Chipset Sata Intel DP45SG motherboard
DVD media Verbatims MKM001 Made in Singapore
ok i did what you recomended and got even worse, it went up to 300 PImax, but i did not save the grafic, then i did another burn at the original setting and got a new chart a better one but and the end the same problem rising up, only to 30 max this time, in conclussion i dont know what makes a better burn every one seems to have they singular behaviorI was recieving the same results from my backups when using MKM001 Singapore Verbs... (the rising spikes at the end of the second layer of the disc)
As I have learned, and as has been posted in another forum, try the following:
Download MediaCodeSpeedEdit and load up the iXtreme Burner Max firmware. Set MKM-001 discs to burn using the write speed of the MKM-003 Verbs (4x, 6x, 8x).
This enables you to burn the MKM-001 discs at 4x with OPC enabled. I have been getting 'perfect' discs doing this.
This is a link to the discussion about burning MKM-001's at 4x with OPC enabled: http://team-xecuter.com/forums/showthread.php?t=74097
Again, remember that you need to download MediaCodeSpeedEdit to change the iXtreme Burner Max fw so that you can burn at 4x on MKM-001's.