RGH xell boot fine ,freeboot don't !

[Ankoholik]

Used coolrunner
nand read by nand-x

Chip installed OK
xell booting within 3-7 sek

I have cpu key

creating freeboot 13604 ,writing by usb rawflash v3

starting console by power and blackscreen

What i do wrong?

I done before jasper 16 mb fine no probs
now i have jasper 256/512 MB (not sure because xnandhealer show my nand as CB6750 jasper512mb and i see by xnandhealer that my nand chip flash is only 256 mb (212 mb free in dash before)

Please help

PS: I write stock nand by command -w64 and stock work again fine !

 

[d4rk_4ng3l]

Are you planning to do reset glitch hack again or not? If yes, then at which point are you on exactly?

 

[joelj]

Ok this happens a lot.

Can I give you a suggestion? Use the 360 multibuilder by rogero to build your boot image.

Start xell. Insert your flashimage.bin and xenon.elf in a USB. It will flash it for you. This is by far the most successful method.

 

[Ankoholik]

org boot fine
freeboot don't( 360 multibulider ,xnandhealth,jtag tools ,gg bulid)

any sugestions?

 

[AudioProUK]

did you dump the nand properly (nandpro usb: -r64 filename.bin for big block jasper)

 

[Ankoholik]

yes

-r64 for read

orginal nand wtote by -w64 and works ,(by +w64 gets e79)

 

[Ankoholik]

rawflash v3 and image created by 360multibulider v4 by rogero

xell starts ok ,reading from usb and

block seems be bad error 000000240

and that on all blocks

 

[diaboliq20]

you get that on all blocks?

 

[Ankoholik]

yes

I write this image by nand-x and xell boots ok but freeboot don't

I will write org nand leave this f*cking xbox alone

 

[diaboliq20]

so you're using the right cpu key and the original correct nand to generate the freeboot

 

[Ankoholik]

first time freeboot starts but he was very slow and freez about 30 sek

i reflash with rawflash v3 and for that moment only org work

 

[ishockin]

Why not write the NAND back using Nand-X?

 

[homebro2000]

try to check the cb version of the original nand and custom dash nand. if it does not match.

Sent from my PG86100 using Tapatalk

 

[Ankoholik]

CB it's OK

I write ORG nand and have 3ROD with 0022

 

[diaboliq20]

what have you done to the original NAND? have you changed the original working dump in some way? or updated the dash?

 

[Ankoholik]

orginal nand is orginal ,not updated
yesterday work perfect
today 3rod

 

[Ankoholik]

I solved my 3 ROD problems and freeboot boot

I have japser 256/512

Write ORG nand and 3 red lights then

Write ecc image by +w16(I know that I have 256/512 nand)
Write glitch image by -w256

It works OK but sometimes start animation is freez or NXE Dash can freez after (30-60 sek)

when i Launch xexmenu or dashlaunch console work perfect so i set dashlaunch and when console didn't freez on start animation it works ok (1 about 5 times)

Any suggestions for this freez?

Hi