Xell for Corona V6 with Win-bond ram

fokeiro

Senior Member
Feb 1, 2010
125
0
MIAMI, FLORIDA
im trying to glitch a corona v6 and was stuck on infinite glitch and just realized it has the winbond ram, and i saw there is xell and freeboot for this version but cant find it on jrunner, where or who can i get it and does it work with any other chips liek coolrunner or we have to wait for new chip ?
 

ultimate360

VIP Member
Nov 11, 2013
786
48
MN, USA
I believe there is a few files of the custom xell going around, but I won't trust them until they are in j-runner. Your best option is to wait for cr4, hopefully it won't be much longer to release :). Also yes, xecuter has said there will be a release for compatibility with older chips and use the same new code, but I cannot promise that will be delivered as I haven't seen a word about it since the reveal day of the cr4 back in May.
 

fokeiro

Senior Member
Feb 1, 2010
125
0
MIAMI, FLORIDA
so i just flash this like a regular ecc then try to boot??? with my uck i will still get stuck on endless glitching, and should i get image using hdmi or only ethernet ?
 

fokeiro

Senior Member
Feb 1, 2010
125
0
MIAMI, FLORIDA
Maybe u can help me with this im trying to flash the retail nand bavk and test xbox works fine prior to attempt this xell but when i turn xbox on eother i get stuck while the green lines appear to put the xbox sign together or i get red loght with e79 error....should i remoce coolrunner and qsbs and also the bridged pads unbrodged and bridge r1r1 or what could it be
 

ultimate360

VIP Member
Nov 11, 2013
786
48
MN, USA
Maybe u can help me with this im trying to flash the retail nand bavk and test xbox works fine prior to attempt this xell but when i turn xbox on eother i get stuck while the green lines appear to put the xbox sign together or i get red loght with e79 error....should i remoce coolrunner and qsbs and also the bridged pads unbrodged and bridge r1r1 or what could it be
Could be hard drive, bad flash, brigded connection somewhere. Why did you bridge r1r1?
 

fokeiro

Senior Member
Feb 1, 2010
125
0
MIAMI, FLORIDA
Well it was vridge from factory with a resistor but i removed it as per some tutorials...now still unbridged just asking if i need to bridge for retail to work
 

ultimate360

VIP Member
Nov 11, 2013
786
48
MN, USA
No, if you remove it, leave it removed. It has never caused an issue for me on retail with it removed. I usually just default to remove it right away whenever a v6 comes in for rgh. I would try another image and see what happens, check your nand soldering as well
 
Jul 19, 2014
202
0
Sunny Florida
If you want to boot stock, desolder the red 3.3v wire from the Coolrunner. Make sure the microSD PCB switch is set to X360.

font201211061111436406.jpg

If any unexpected crashes happen, desolder the blue wire (cpu_rst) from the motherboard and put a piece of electrical tape over the exposed wire.
 
Last edited: