XeLL Won't Read From USB?

[TGKohler]

TX Product(s) used: Rev C
Console Type: Trinity
NAND size: 16
Dashboard version: 16747
CB version: e.g 5771

Description of problem:

I was trying to flash a banned KV onto my RGH, but when I did, it wouldn't boot up. I can boot into XeLL and I had a fresh NAND build ready on the root of my USB so I could flash it. It doesn't read from the USB and I've even tried unplugging everything, etc. There are NO bad blocks.

It pauses at something in XeLL about a Xbox 360 controller and then goes down to sata and fuseset stuff after about 30 secs.

Was the console working before you started: Y

Do you get a green debug light appear on the RGH chip every 4-5 seconds: Y

How long is the light on for each time: Around 5 seconds. Not sure.

 

[alexander_1333]

How do you rename the image?Try updflash.bin.If it will not work, you can always write the nand with a HW flasher.

 

[gazcoigne]

is your usb drive formatted in NTFS?

360 can only read FAT32 or HFS+

 

[Slayertex6]

You say it's a trinity and it has cb 5771, you done messed up somewhere along the line. Sometimes I've had Xell not wanting to read updflash.bin. Put the xenon.elf with it and it should boot.

 

[TGKohler]

You say it's a trinity and it has cb 5771, you done messed up somewhere along the line. Sometimes I've had Xell not wanting to read updflash.bin. Put the xenon.elf with it and it should boot.

I'm so sorry. I forgot to put what CB it is. (it's 9231 btw). Also, is there a specific xenon.elf file I should use? I didn't make this console, so I don't know a lot about it. I just deal with making software.


Others, the name is updflash and the flashdrive is indeed FAT32. (I formatted it to FAT32 multiple times to make sure)

EDIT: All it's looking for is TFTP. If I don't have the USB in, XeLL would go super fast and also say there is a memory unit (I guess my 4GB card), but when it's in, it freezes at USB bus 1 device 2: vendor 045E product 02AA class FF: Xbox 360 Controller and takes about 30 secs to progress.