Xenon E79 after Xell

[drumr7123]

Okay this xenon is on the 6690 dashboard, the CB is 1903, I am using Nand-x V2 and I have used the team-xecuter qsbs for the jtag part of it, it got e79 so I used the 2 diodes method and that didn't work, after I used the 3 330 ohm resistors and now that doesn't work, I am checking all my solder joints with an ohm meter and they are all good, any ideas?

 

[BL4K3Y]

How did you write XeLL to the console and which file did you use?

 

[drumr7123]

I did it through the 13599 dashboard jtag tool through nand-x with wires soldered to the board, no qsb for the nand part itself

 

[BL4K3Y]

In your NAND-X kit, you should have a QSB for Xenon JTAG (J1F1 I think it's called).

If possible, use that in combination with J2D2..... see this image.