JTAG Xenon E79 Booting Xell

[XEX DriZzy]

When I boot xell it gives me one red led with E79 on the screen.


Pics: http://gyazo.com/a0c9b8e33f3f0b94ac13baf80317f1a5
http://gyazo.com/9090707ab68d6d3b1c5bfb3d2747d149
http://gyazo.com/91a3672bf3ff913aff717faaea4ad39f

Hope someone knows whats wrong, Thanks

 

[BL4K3Y]

Why don't you use the QSBs supplied with the NAND-X?

Those wires you used are for a Non-Xenon install.

 

[XEX DriZzy]

Yeah I already used them on a different Jtag. I have made about 6 xenon jtags using this method and they have all worked good up until this one. Was hoping there was a solution to fixing it instead of using the E79 jtag kit.

 

[BL4K3Y]

In which case, you may want to try the Xenon E79 JTAG kit.

It was designed specifically for stubborn Xenon units that show E79 using the standard JTAG setup.

You should be able to purchase it from any Xecuter re-seller.

 

[XEX DriZzy]

You sure there isn't any other way to get this thing to boot? Thanks

 

[David Watters]

ive dealt with that b4 on a couple of xenons one i used the e79 kit and the other i tried the old 3 resistor method instead of the 2 diode method fixed.

 

[XEX DriZzy]

So the 3 resistor method fixed the E79?

 

[David Watters]

ya i actually think i still have the jtag in the closet the resistor method works on it but not the diode i would just always get e79

 

[XEX DriZzy]

Damn might as well get the kit then.