FIXED xenon giving e79

[thebomber]

hello guys well this is my first jtag actually, i do rgh all the time, so i came across an exploitable xenon, which is crazy, so i decided to jtag it, so i read the nand and wrote xell, using jrunner, and installed 2 qsb's that came with the nandx, as written per jrunner pics

i boot the console i get e79

what else should i install, there is a cable that came with the nand x with 2 pins, should this be installed or what, sorry to post here but cant find a topic that supports the xenon qsbs.

 

[jsinger47]

e79 is almost always a wiring issue

the e79 jtag kit is almost never required

 

[HcKrSklz]

hello guys well this is my first jtag actually, i do rgh all the time, so i came across an exploitable xenon, which is crazy, so i decided to jtag it, so i read the nand and wrote xell, using jrunner, and installed 2 qsb's that came with the nandx, as written per jrunner pics

i boot the console i get e79

what else should i install, there is a cable that came with the nand x with 2 pins, should this be installed or what, sorry to post here but cant find a topic that supports the xenon qsbs.

if your using the kit that came with the nandx. make sure that you flip the switch on the qsb you soldered to j2d2. default=off so change it to the 470 setting if it still does not work try the 330 setting... booting with the switch in the off position will result in e79 as for the wire yes you need to use the blue and yellow wire that comes with your kit to connect the two qsbs.... Check out this guide it will help you... http://team-xecuter.com/forums/showthread.php?t=54423

 

[Justice1231]

Also check your soldering on the jtag, i did one last week that gave e79, resoldered the jtag and all was good.

 

[webnomix]

Photo's are really needed to have a look at you wireing, but also as above look at the jumper settings on the QSB - this catches a lot of people out as I think the standard shipped setting is with the diodes switched off, so you will get E79 if the Xell or Jtag has been written. Most (99%) of the time if that is not the case, then it is your wireing.

A third thiong to check (more unlikely since you appear to be able to read and write via nand-x) is the voltages and resistance at your jtag points. Had a recent E79 that was down to a failed southbridge, but didnt realise until I checked the voltages.

 

[thebomber]

re checked my solder points and it booted,

woow that was easly like hell.

and i thought rgh was easy

thx alot guys

you just made me jtag my first console