Xenon JTAG e79 (xell boots fine)

[thedemon13666]

Hi,

I have recently JTAGGED a xenon that I have reflowed.

I dumped the nand using the nand-x 5 times and all report to be identical.

There were bad blocks at the following:

25B
25C
25D
25E

I have installed xbr and also tried freeboot.

Xell/Xellous always boot correctly, however when I try to boot into freeboot/xbr the xbox logo stats to show and then it E79s, always at the same point.

I have seen some information about this on the internet however there isnt really a definitive answer.

I am using two diodes and a jumper wire.

I have not used the QSB (rather I solderd wires directly into the holes for the nand).

Please help I am ripping my hair out.

 

[BL4K3Y]

After you create the FreeBOOT image, flash it via Xellous. To do this, rename FreeBOOT.bin to updflash.bin, put it on a FAT32-formatted USB stick, plug the USB stick into the XBOX 360 and boot Xellous. If everything went well, Xellous should find the update and flash it.

 

[thedemon13666]

lollies never mind, I remapped my blocks

herp derp.