Xenon no Power Jtag attempt

[mafia 5k]

Alright i have jtagged a few consoles and everyonce and a while i get this no Power, Power Brick is red !
It happened after installing the nand nand x hmmm ... This one wont turn back on tho it most cases i clean up the points and it truns on is there any reason for this im out lof luck and tired?

So further more its a pre nxe xenon brand new was working out of the box and now im stuck wondering how to fix it ? I installed the nand x wires and went to plug it up and no power = no flash controller

 

[xbobb]

photos of your wiring install ?

 

[mafia 5k]

cant seem to get good shot of the board i tried a video but my camera is not good enough the spots seem to be alright there not burned and there isnt any trace hitt each other ?

 

[DaRkO]

have you checked the underside too?

 

[mafia 5k]

yes i have checked I might try some desolder braid on these points to resettle the solder but has anyone had this problem before ?

 

[xbobb]

it would of been good to see the orignal wiring instal but seeming as its now removed will be a bit hard to see if there was any shorts etc...

try a different power supply and getting the same thing ?

strange it was working out the box but not now after nand x install...

 

[mafia 5k]

it had to be a short but i dont know how to fix this the power brick is not the issue when i gert the chance ill upload pics but my camera is supa blurry

 

[Martin C]

Don't get so close when taking pics - the resolution of your camera is more than enough if you're about 12-15 inches away. We can always zoom in

 

[tony1160]

if you got the message no flash controller ....... its your soldering,
desolder the wires and try booting the console..also did you update it to 7371dash ??

 

[seanr28]

i had the same problem, carefully check the board for splashed solder points, I managed to get a sall blob of soldier accros a very small component, took me a while to see it though! I cant see it being much else, especially if the PSU is red as soon as you plug in the power lead

 

[xbobb]

if you got the message no flash controller ....... its your soldering,
desolder the wires and try booting the console..also did you update it to 7371dash ??

its already been pointed out it was his wiring install and something has shorted out as the console will no longer power up