JTAG xenon wont turn on, and power brick red

C

crazy-gamer

VIP Member
May 10, 2011
171
0
alright so when i plug my power supply into my jtag the light turns red. i tried turning the jtag on and it doesnt do anything

but when i plug the cord into my retail, it works fine.

any body know what the problem could be?
 
C

crazy-gamer

VIP Member
May 10, 2011
171
0
oh i hope its not the mother board. :(

this is bumming me out, i just actually was gonna update my dash, and while i was sitting there it turned off.

is there any solution to this? or would i have to go into a lot of work for it.
 
1

1almasmith

Senior Member
Aug 3, 2011
147
0
I just had my jasper turn three red light and would not power on at all but when I wrote the orginal nand back to it it works. Try that worth it.

---------- Post added at 19:12 ---------- Previous post was at 19:11 ----------

Ok it won't come on might be another problem
 
T

talamalopilis

Full Member
Mar 7, 2010
96
0
Canada
it would take a lot of work, and even then you might not figure it out. to start, look into solder points and see if they havent broken off
 
D

dec0y7

VIP Member
Apr 15, 2010
160
0
Sheffield uk
was it working fine before today?

if so look at the usb slots as ive have load brought to me with the no power problem and every time its because of the pins inside one of the usb's touching,
worth a look just to rule it out
 
C

crazy-gamer

VIP Member
May 10, 2011
171
0
dec0y7 said:
was it working fine before today?

if so look at the usb slots as ive have load brought to me with the no power problem and every time its because of the pins inside one of the usb's touching,
worth a look just to rule it out
Click to expand...

im gonna try that, it was working fine just today and i never did have a problem. i dont get RROd either so idk what it could be, im gonna try it now
 
You must log in or register to reply here.