I try to flash my xbox360 dvd-drive now using Xtreme bootmaker since it seems easiest. Perhaps you wanna know that I have a P4P800-Deluxe motherboard. However, in the program i write in my serial number
360 Serial Number
xxxxxxx xxxx
Then choose
Xtreme 5.x A
Report as Samsung TS-H943A-MS25
Destination drive G:/ (this is where I have my USB-drive)
After this i go to General Options and open firmware and choose my xtreme52.rar
Then I go to MTKflash options. Use custom controller
List IDE-Drives and find Primary and Secondary IDE-channels, but they don't work.
So I continue and find
Ultra ATA storage controllers 24DB and Ultra ATA storage controllers 24D1
and in LIST SCSI controllers I just find A347SCSI controller.
The only one of these three that gives a ID and IO is Ultra ATA storage controllers 24D1, so I chose that one. Then I make the usb-drive bootable by checking the box at Create basic disc and pressing Create Disk.
But when I start the computer and try to flash I find the Pri Xtreme but nothing happens when trying xread or xflash.
When I press escape I usually get an error 52 I think it was, can't remember right now. Sometimes tough I get the 00 or 80 error.
So, what should I do?
Sorry for bad english, blame my teacher.
Thnx in advance
//MrMult
360 Serial Number
xxxxxxx xxxx
Then choose
Xtreme 5.x A
Report as Samsung TS-H943A-MS25
Destination drive G:/ (this is where I have my USB-drive)
After this i go to General Options and open firmware and choose my xtreme52.rar
Then I go to MTKflash options. Use custom controller
List IDE-Drives and find Primary and Secondary IDE-channels, but they don't work.
So I continue and find
Ultra ATA storage controllers 24DB and Ultra ATA storage controllers 24D1
and in LIST SCSI controllers I just find A347SCSI controller.
The only one of these three that gives a ID and IO is Ultra ATA storage controllers 24D1, so I chose that one. Then I make the usb-drive bootable by checking the box at Create basic disc and pressing Create Disk.
But when I start the computer and try to flash I find the Pri Xtreme but nothing happens when trying xread or xflash.
When I press escape I usually get an error 52 I think it was, can't remember right now. Sometimes tough I get the 00 or 80 error.
So, what should I do?
Sorry for bad english, blame my teacher.
Thnx in advance
//MrMult