RGH zephyr board trying to add low shield cable

[rick48235]

whre can i put the low shield cable on my zephyr board. is it a place on top. my zephyr wont boot.. i read on it but cant find much where to put it.

 

[rick48235]

i ran it through the big hole in front of the fan.

 

[rick48235]

no luck i guess i will wait on rgh 2

 

[jeremy790]

RGH 2.0 might not fix the problem. Why don't you post some pics and give a little more info on what it is doing

 

[T3chWarrior]

I used wifi cable on my zephyr and i ran it on top of the board, on the cpu rst wire

http://team-xecuter.com/forums/showthread.php?t=84048

you dont have to get picky on where you put it just try somewhere and see how it goes, from what ive heard each is different.

 

[T3chWarrior]

the xenon rgh thread also covers cable placement

http://team-xecuter.com/forums/showthread.php?t=83396

 

[m0j0j0_j0]

You need more information, are you trying to rgh a 14717/14719 dash? because if so then yes you will need to wait for rg2.0 else you're soldering is bad. when you say it doesn't boot do you mean fans don't turn on or the coolrunner just sits there and flashes green?

 

[rick48235]

thanks guys iam going to sell it as it is i got 7 jaspers i can do it on. iam on the 1499 dash i know that dont go any higher

---------- Post added at 03:54 ---------- Previous post was at 03:52 ----------

i just did a jasper and went fine