Zephyr glitched and flashed - now nothing
- Thread starter metaldog99
- Start date
rs250
Full Member
Don't know yet... I have not had 10 min to spare to get to it and give it a go but hopefully tomorrow.
I have been using Multibuilder so not sure if it is going to help (can't hurt) but going to try moving the STBY-CLK to alt point and then going with new image w/out dash launch patches to see what happens.
Cheers
Last edited:
rs250
Full Member
I had one of my zephyrs that won't boot a 13599 image but boots the 14xxx dash perfectly. Good luck
rs250
Full Member
Well, I did give up on the Zephyr for the time being, too much time in it to quit all together.
Went ahead and threw the CoolRunner in a BB 512 Jasper and it boots first hit every single time 3 to 5 sec (no cap.). Now that is how it is supposed to be and shows the CoolRunner is a sweet piece of kit.
Cheers
Went ahead and threw the CoolRunner in a BB 512 Jasper and it boots first hit every single time 3 to 5 sec (no cap.). Now that is how it is supposed to be and shows the CoolRunner is a sweet piece of kit.
Cheers
i can attest to the stby clk point causing the "usb device not detected" when trying to read nand or flash it. i have a slim and that was one of my problems. if the nandx prgrams the cr witht he xsvf file then the nandx is working, atleast one would think.
but as others have said the zephyr is tough. those solder points are brutal. i have a benq thats failing in my old zephyr, its 30 bucks for a new drive or a cr. might try the cr just as an experiment.
natedogg, i will try the option 2 when i get around to it. thanks
but as others have said the zephyr is tough. those solder points are brutal. i have a benq thats failing in my old zephyr, its 30 bucks for a new drive or a cr. might try the cr just as an experiment.
natedogg, i will try the option 2 when i get around to it. thanks