Good Evening,
I have been looking through all guides and I am stuck. I bought the Xecuter CR4 XL with V3 QSB and v2 Programmer. I cannot find an install that just uses those items. All installs are using other Phat QSB and do not show directly to the motherboard. I wired up the CR4 as best as possible. Power and ground, and points A,B,C,M. On the bottom of the board I have the v3 QSB soldered the motherboard, and have the green wire soldered to the Q2N1. The v3 QSB does not have any switches just one jumper. I cannot find a clear point for the B point to solder too. I am currently using a point next to the 5v connection. The XBOX still powers on and the Xecuter shows a red led. Not sure what do at this point. Any help would be appreciated. Thanks!
I have been looking through all guides and I am stuck. I bought the Xecuter CR4 XL with V3 QSB and v2 Programmer. I cannot find an install that just uses those items. All installs are using other Phat QSB and do not show directly to the motherboard. I wired up the CR4 as best as possible. Power and ground, and points A,B,C,M. On the bottom of the board I have the v3 QSB soldered the motherboard, and have the green wire soldered to the Q2N1. The v3 QSB does not have any switches just one jumper. I cannot find a clear point for the B point to solder too. I am currently using a point next to the 5v connection. The XBOX still powers on and the Xecuter shows a red led. Not sure what do at this point. Any help would be appreciated. Thanks!