Zephyr JTAG Wont boot XELL gets RROD

Status
Not open for further replies.
C

Chase Resolute

Junior Member
Mar 15, 2014
22
0
Las Vegas, Nevada
Hey guys i have a Zephyr that i have been trying to JTAG and it was on dash 5766 and i tryed to JTAG it and it boots fine on stock image but when i wrote xell i got RROD one ring on the bottom right. then i read about it had to be updated to 7371 so i updated and tryed again the jtag wiring and i still got the 1 rrod it boots stock perfectly so i have no clue what is worng and it is making me angry so any help would be appreciated i used kynar wire for the jumper then i used the smitching diode to the bottom left corner point the soldering is good i have intermediate experience and i have soldered and desoldered multiple times and i have the wire that goes to the rol on the alternate side on the bottom with the diode soldered to more kynar and that about sums up my install i dont think pictures are needed because jtag is a simple install and my soldering is good also forgot to mention i dont have a split cb the cb is 4558

also could anyone post HDMI jtag tutorials that are good i will try that wiring because im desperate lol
 
BL4K3Y

BL4K3Y

VIP Member
Jul 7, 2010
13,721
118
Colne, Lancashire (UK)
Chase Resolute said:
I need it for a friend who think he may have found out a good method to like reverse engineer them its hard to explain and i also want the console jtagd for myslef can you please just help
Click to expand...
If you friend thinks he has the knowledge to "reverse engineer" them as you say, he should know how to obtain one.

This is not an issue for us to deal with.

Thread closed.
 
  • Like
Reactions: Hrag123
Status
Not open for further replies.