Zephyr succesfull RGH
- Thread starter theboyfromthemoon
- Start date
I just did my first Zephyr and it glitches almost instantly. I used shielded wire and wired the system the same way it is shown in the TX Xenox RGH tutorial. I even added the capacitor.
BL4K3Y
VIP Member
I believe more people are having success when using shielded coaxial cable on CPU_RST.
Congratulations to the OP, Zephyr consoles are usually a modder's worst nightmare to RGH
!
Congratulations to the OP, Zephyr consoles are usually a modder's worst nightmare to RGH
!Interesting read. The last box I RGH'ed was a zypher, but it glitches every time no problem. When I get home I check to see which chip it has...
After alot of trials and errors I managed to get reliable boots... used shilded wires, cpu_rst on top of vents duct, wires not crossing... but it glitch only this way:
-cold boot - no glitch - after 1 min. - power cycle - glitch
If I connect the dvd-rom it doesn't boot... I can live with that...
the interesting fact
I had to connect 2v from motherboard to the 1,8v line on cpld, tried 1,8v from mosfet but no go (very poor glitch)... only 2v made a difference... and try avoiding the coils and power lines/mosfets.
-cold boot - no glitch - after 1 min. - power cycle - glitch
If I connect the dvd-rom it doesn't boot... I can live with that...
the interesting fact
I had to connect 2v from motherboard to the 1,8v line on cpld, tried 1,8v from mosfet but no go (very poor glitch)... only 2v made a difference... and try avoiding the coils and power lines/mosfets.
Last edited: