RGH zephyr why do you hate me?

[tonyjandc]

some people use alt point for blue across top of board by fans try that sorry to sound negitive but zephs are hit and miss I a have a halo 3 box sitting here but is frightend to give it a go thats a zeph as well

 

[hampsterlamp]

na i give up my brother can just deal, new question how do i restore to stock? ive never done it before...so i have no clue

 

[jeremy790]

I will also add for my board I had to create and write the ecc several times to get it to work.

 

[tonyjandc]

ok if you give up just rewrite your orginal nand back to board and switch cr to prg that will switch it off

---------- Post added at 15:34 ---------- Previous post was at 15:33 ----------

the other thing before you give up try changing the cr timing to falcon that sometimes helps

 

[jeremy790]

some people use alt point for blue across top of board by fans try that sorry to sound negitive but zephs are hit and miss I a have a halo 3 box sitting here but is frightend to give it a go thats a zeph as well

From reading some zephyrs will never glitch

 

[hampsterlamp]

write the whole nand with nandpro?

---------- Post added at 17:36 ---------- Previous post was at 17:35 ----------

what prog could i use for writing falcon timing jrunner makes me use zephyr cause i wanted to try that

 

[tonyjandc]

you can programme cr before doing anything else just click flash cr and select falcon

---------- Post added at 15:43 ---------- Previous post was at 15:38 ----------

remember green light might not flash as board has been pre programmed

---------- Post added at 15:44 ---------- Previous post was at 15:43 ----------

dont panic though even try xenons timings that might work

---------- Post added at 15:46 ---------- Previous post was at 15:44 ----------

jeremy zephs have a mind of their own as we know lol

 

[hampsterlamp]

ive given up im returning it to stock

 

[sarah1331]

Lol never be beaten lad

 

[tonyjandc]

as the nun said to the bishops give it a bash lol dont be beaten beat the box

 

[hampsterlamp]

apparently this thing wants to keep going....i wrote stock nand and it gave me a 0022

 

[sarah1331]

ZHow long does it take to rrod have you removed any wires?? This could also be why it wouldn't glitch. Tale some nice pics of your yellow and green wires under the board

 

[hampsterlamp]

idk 5-10 seconds all wires still attached and cr on prog

---------- Post added at 18:08 ---------- Previous post was at 18:07 ----------

way off 35 seconds...

 

[sarah1331]

Like in my previous pics please of your green mainley it could also mean your ldv is incorrect try building an image raising it by one but if try glitch to xell to tell first

 

[hampsterlamp]

check pages 1 and 2 for pics

 

[DayvG]

I have a Halo 3 Zephyr and routed the CPU_RST topside and it boots as good as a Falcon. You could try insulating your wires, might help.

 

[sarah1331]

Your green wire is fuzzy when i zoom in to see the solder joint in the pic it looks too long of an end but I just cannot make it out correct

 

[hampsterlamp]

well out of 5 pics thats the best...

 

[sarah1331]

Oh ok it looks like you have too much exposed wire I zoom in and it goes fuzzy if you take a closer pic it will be better for me that's all this could be the answer to your rrod

 

[hampsterlamp]

took off green wire clean up extra solder and it booted dash